Kohler Comfort Height K-77795-0 Eir Instrucciones De Instalación página 11

8. Install the Docking Station
38" (965 mm) -
66" (1676 mm)
Docking Station
Position the mounting bracket at the desired location.
Confirm that the bracket is level.
Using a pencil, mark the two mounting-hole locations.
For installation into a stud or other wood surface: Drill a 1/16" (2 mm) hole at each of the marked locations.
For installation using wall anchors: Drill a 1/4" (6 mm) hole at each of the marked locations. Install the provided wall
anchors into the holes.
Position the bracket over the anchors or marks. Secure with the provided screws.
Open the back compartment on the docking station by pushing both tabs outward at the same time.
Install the four provided AA batteries in the orientation shown.
Reinstall the cap to the battery compartment.
Residential
Position the docking station on the bracket.
Place the remote control on the docking station.
Commercial
To make the remote control tamper-resistant, secure to the docking station using the supplied washer and screw.
Install the dock plate to the docking station with the four screws.
Position the docking station on the bracket, which will be offset to the left.
Firmly push down on the docking station to fully seat onto the bracket.
Kohler Co.
1/16" (2 mm) or
1/4" (6 mm) Holes
36"
(914 mm)
For Tamper
Resistant
Commercial
Dock Plate
11
Residential
1295780-2-B