7. Complete the Installation
IMPORTANT! Do not install the access covers until the 100% silicone sealant has cured.
Turn ON the water supply.
Check all connections for leaks.
For plug-in installations, plug the power cord into the outlet.
For hardwired installations, turn on the electricity to the circuit.
Press the power switch to turn the toilet ON. The toilet will complete a startup cycle.
Apply 100% silicone sealant around the base of the toilet as shown. Do not apply sealant where the access covers meet
the floor.
Attach the access covers.
1295780-2-B
Power Switch
10
Kohler Co.