i-tec C31DUALKVMDOCKPD Manual De Instrucciones página 13

INSTALLING DRIVERS ON MAC OS X
WARNING! If you do not install the ASIX driver, the RJ-45 (Ethernet) may
not work on your macOS device.
Download the drivers from our website www.i-tec.cz/setup under
the „Download" tab for this product and start the installation of: driver
ASIX 88179
HARDWARE INSTALLATION (CONNECTING THE DOCKING STATION
TO THE MACBOOK)
1) Turn on your MacBook and connect the power adapter to the dock.
2) (Optional) Plug the dedicated switch button into the rear 3.5mm
switch port. (This button can be used to turn the docking station on
and off, switch between PC1 and PC2 inputs)
3) Plug the power adapter of the docking station into the AC 110 V /
230 V mains and press the ON button.
4) Plug the USB-C cable into the USB-C port on the back panel of the
dock.
5) Plug the other end into a free USB-C or Thunderbolt
your device.
6) The automatic installation of the ports will then begin.
7) After the installation is complete, restart your MacBook.
INSTALLING DRIVERS ON OTHER OPERATING SYSTEMS
These are available for download on our website under the „Download"
tab for this product or here: www.i-tec.cz/setup
Quick Start
3/4 port on
TM
| 13
ENGLISH