Leak Testing; Before Testing; Care And Maintenance; Oven Interior - Ooni Koda 12 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Leak testing

General
Although the gas connections of the appliance are leak tested prior packing and shipment, a complete test must
be performed at the installation site.
Before each use, check all the gas connections for leak testing using the procedure listed below. If the smell of
gas is detected at any time, you should immediately stop using and check the entire system for leaks.

Before testing

Make sure all packing material has been removed from the appliance.
Make a solution of one part liquid detergent and one part water. You will need a spray bottle, brush or rag to apply
the solution to the fittings.
To test
1. Turn the burner valve OFF.
2. Turn the liquid propane cylinder valve on counter-clockwise to open the valve.
3. Apply the soap solution to all gas fittings. Soap bubbles would appear where a leak is present.
4. If a leak is present, immediately turn the gas supply OFF and tighten leaky fittings.
5. Turn the gas back ON and recheck.
6. Should the gas continue to leak from any of the fittings, turn the gas supply OFF and contact customer service.

Care and maintenance

Store Ooni Koda 12 out of direct sunlight and indoors where possible and when storing for extended periods of
time. Ooni Koda 12 should not be exposed to harsh weather conditions such as snow, heavy rain and
strong winds.
Wait for Ooni Koda 12 to cool completely before moving
The outer shell of Ooni Koda 12 may fade over time and through use. This will not affect performance.
Stone baking board
1. DO NOT use the stone over an open flame
2. Avoid extreme temperature change to the stone. DO NOT place frozen foods on a hot stone
3. The stone is fragile and can break if bumped or dropped
4. The stone is very hot during use and stays hot for a long time after use.
5. DO NOT cool the stone with water when the stone is hot
6. After cleaning the stone with water, please dry the stone before use. This can be done in a conventional oven
at 60°C (140°F) for 2 hours.
7. Burnt on food can be cleaned by flipping the stone where it will clean itself due to the high oven temperatures

Oven Interior

Wipe down with a paper towel between uses to remove any debris.
Other areas of oven
Clean when required using a non abrasive sponge
10

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Koda 16

Tabla de contenido