Using The Oven - Ooni Koda 12 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operating instructions

Using the oven

Each burner is rated at 13,300 BTU/Hr.
To begin:
1. Make sure the oven has been leak tested and properly placed.
2. Remove any remaining packing material.
3. Light the burner using the lighting instructions below
Lighting instruction
To light the burner
Read all instructions before lighting.
1. Make sure the control knob is in OFF position, and then turn the liquid propane cylinder valve ON by slowly
turning counter-clockwise.
2. Push in and slowly turn the control knob anticlockwise until you hear a click and the burner ignites.
3. Continue to push in the control knob for 5 seconds after ignition and then release.
4. If burner doesn't light within 5 seconds, turn the knob OFF, wait 5 minutes and repeat the lighting.
To light with a match
1. If burner will not light after several attempts using the control knob, the burner may be lit with a match.
2. If you have already attempted to light the burner using the control knob, wait 5 minutes for any gas
to dissipate.
3 Insert a match into the matchstick holder, ignite the match and insert through the oven opening to the burner.
4. Push and turn the control knob to HI slowly, the burner should ignite immediately.
5. Continue to push in the control knob for 5 seconds after ignition and then release.
6. If the burner does not light within seconds, turn the control knob OFF and wait 5 minutes and try again.
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Koda 16

Tabla de contenido