All manuals and user guides at all-guides.com
8305H-All_Manuals 8/18/14 8:02 AM Page 6
Mode Key
Push the MODE key to switch from one construction language
to another. This controls which construction language your
electronic module will measure in. Your level has the capability to
measure in Degrees, Percentage of slope, Millimeters per Meter, Inches
per Foot (Slope/Pitch) in decimal form and Inches per Foot in fractions
of an inch. A symbol on the upper right of the screen will display
which MODE you are currently in.
Hold/Backlight Key
Set the level in place and press this key a short press to enter
into the hold status, record the current angle of the flashing
display, the displayed value will not change. Press this key again to
release the hold and the data will vary according to slope. A long
press (more than 2 seconds) will turn on the LCD backlight.
Power On/Off Key
Power on and off the instrument by pressing this key.
Automatic Shut-off
This instrument will shut-off automatically if no operation is received
within 20 minutes.
6
©2014 Johnson Level & Tool - Rev. 3