ACCESSORIES
When you open the packaging, check that all the accessories are present:
1x battery saw
2x Batteries
1x Charger
1x Instruction manual
BATTERY CHARGING
• Do not expose the battery to extreme conditions, such as high temperatures or electric
shock. Failure to do so may result in injury from spillage of the electrolytic solution.
• Before charging, check that the battery is clean and dry.
• At delivery, the battery of this device is not fully charged. Therefore, before first use,
charge the battery properly.
• Do not charge the battery for long periods of time or let it finish charging completely
as this may damage the battery.
• The guarantee does not include faults due to misuse.
• If the battery has been charged and has no power, it will need to be replaced as it may
be obsolete.
• The user should only use batteries produced by the manufacturer.
• Always bear in mind the safety instructions, protection requirements and
environmental information.
1) Store the battery in a 10 to 22m wide, dry and ventilated place.
2) Check that the appliance is switched off.
3) Install the battery in the machine housing.
4) Check that the voltage matches the values on the charger and adapter.
5) The red light on the charger, indicates that the battery is charging, the green light
indicates that charging is complete. The average charging time is 3 hours.
6) When charging is complete, disconnect the charger from the mains and remove the
battery from the charger.
7) Make sure to charge the battery at least every 3 months.