Frequency band(s) in which the radio equipment operates
2400MHz-2483.5MHz.
Maximum radio-frequency power transmitted in the frequency
band(s) in which the radio equipment operates: 20dBm.
In case of smoke or burning
smell, turn off the power supply
and contact the service center.
If the problem persists, the unit
could be damaged and cause
electrical shock or fire.
The power supply must be
equipped with a special circuit to
prevent fire.
Otherwise, it may result in fire or
electric shock.
When cleaning the unit, stop
operation and turn off the power.
Otherwise, may occur electric
shock or damage.
Check if the installed media is
sufficiently stable.
If damaged, it can cause the
equipment to fall and cause
injury.
V 07/21
WARNING
It is necessary that power supply
adopts the special circuit with
protection through an air switch
and ensure it has sufficient
capacity . The unit switches on or
off automatically according to
user needs: do not turn on or turn
off
otherwise it could suffer harmful
effects.
Disconnect the power supply if
the air conditioner is not used for
a long time
Otherwise, the accumulation of
dust can cause overheating.
The voltage rating of this product
is 220 - 240V, 50Hz. The
compressor vibrates strongly if
Interrompere
l'alimentazione
the voltage is too low, causing
elettrica.
damage to the cooling system.
The electrical components are
easily damaged if the voltage is
too high.
Do not climb on the outdoor unit
or place anything on it.
The falling of the outdoor unit can
be dangerous
the
device
frequently
Do not cut or damage the power
cords and control cables. If the
power cable and the cable of the
control signal are damaged, they
must
be
replaced
professional technician.
Do not damage the power cord or
use an unauthorized cable.
Otherwise,
it
may
overheating or fire.
Do not attempt to repair the air
conditioner yourself.
An improper repair can cause fire
or electric shock. For this reason,
it is advisable to contact a service
center for repairs.
Earthing: The unit must be
properly grounded. The cable
grounding must be connected
with the appropriate device in the
building.
by
a
cause
25