Outdoor Unit Installation - Argo DUAL 14 DCI R32 Manual De Instalacion Y Uso

Outdoor unit installation

For all connections refer to the wiring diagrams supplied with the unit. If the outdoor unit was connected
to a higher level than the one of the indoor unit, you must make a siphon. The outdoor unit must be
installed outdoors, in a perfectly horizontal position, respecting the minimum distances to allow the air
to flow and the execution of any maintenance. The unit is built with resistant materials to protect it from
any weather condition so it's not necessary to protect it in a particular way. Make sure however that
the heat exchanger is not exposed to the danger of hail. If you want to attach the unit to a wall, use
brackets appropriately sized to support the weight of the unit. Condensation produced due to the
operation in heating can be piped to a drain using the appropriate predisposition.
Fix the outdoor unit support
1.Choose the location of the system based on the structure of the house.
2.Fix the support of the outdoor unit in the chosen position with expansion screws.
Note:
Take sufficient protective measures when
•
installing the outdoor unit.
Make sure that the stand can support at least
four times the weight of the unit.
• The outdoor unit must be placed at least
3cm above the floor in order to install the
drain joint.
• For the unit with refrigerant capacity of
2300W ~ 5000W, 6 expansion screws are
required; 8 expansion screws are required
for the unit with 6000W ~ 8000W cooling
capacity; For the unit with refrigerant
capacity of 10000W
expansion screws are required.
V 07/21
~ 16000W, 10
32