GB
1. About this document
Please read carefully and keep in a safe place.
– Under copyright. Reproduction either in whole
or in part only with our consent.
– Subject to change in the interest of technical
progress.
Symbols
!
Hazard warning!
Reference to other information in the
...
document.
2. General safety precautions
!
Hazard from vapours or electrolyte fluid!
Vapours or electrolyte fluid may escape
if the rechargeable battery is damaged or used
improperly. Coming into contact with them may
result in severe injury (e.g. loss of sight, acid burns).
• Never open the rechargeable battery enclosure
or the rechargeable battery itself.
• Do not allow vapours or electrolyte fluid to come
into contact with your eyes. In the event of
contact with eyes:
– Do not rub your eyes.
– Immediately rinse eyes with plenty of clean
water (such as tap water).
– Seek medical advice.
• Do not touch any electrolyte fluid that has
escaped.
• Immediately move product away from naked
flamed or sources of heat.
• Immediately remove contaminated clothing.
!
Hazard from LED light!
Looking directly into the LED light when it is ON
could damage your retina.
• Never look into the LED light at short range or
for any prolonged period (> 5 minutes).
– The light must not be installed in explosive
atmospheres.
– For trouble-free operation, choose an installation
site that is not exposed to vibration or shock.
– Protect the solar panel from mechanical strain
(e.g, tree branches).
– The product must not be modified or altered in
any way.
3. XSolar L-S One
Proper use
– SensorLight with LEDs as the source of light.
– For mounting on outdoor walls.
– Automatically provides light at places where no
mains power is available.
– With independent power supply from solar
panel and rechargeable battery.
– Autonomous detection of the smallest of move-
ments by means of integrated infrared sensor.
Finishes
– XSolar L-S white (EAN 4007841671006)
– XSolar L-S silver (EAN 4007841671013)
Package contents (Ill. 3.1)
Product dimensions (Ill. 3.2)
Product components (Ill. 3.3)
A
Solar panel
B
Motion detector
C
LEDs
D
LED panel
E
Micro USB charging socket
F
Compass
G
Programme selector switch
Setting range for solar panel / LED panel (Ill. 3.4)
Technical specifications for SensorLight
– Output: 6 LED, 1.2 W max.
– Infrared system
– Angle of coverage: 140°
– Detection reach:
8.0 m max. (installed at a height of 1.8 m)
– Area illuminated: 30 m
– Light-level setting: 2 lux
– Time setting: software-controlled, 10-30 sec.
– Basic light level: 3 %
– Luminous flux: 150 lumens / 124 Lm/w max.
– Colour temperature: 3,000 kelvin
– Solar-panel turning angle: +180°/-150°
– Solar-panel tilt: 55°
– LED-panel turning angle: +/- 60°
– LED-panel tilt: 55°
– Protection class: III
– IP rating: IP 44
– Temperature range: -20 °C to +40 °C
– Dimensions (WxHxD): 189 x 298 186.5 mm
– 8 –
– 8 –
2