Sensor Wiring - Bell TotalFit Manual De Instrucciones

Route the sensor wire up the fork blade, using the
twist ties to secure it at the bottom and crown.
Wire must not hang loosely. Leave enough slack to
allow wheel to turn right and left freely. Route the
remaining wire around the front brake cable and
to the handlebar. Excess wire should be carefully
looped and secured to the stem with a twist tie.
Note: Make sure twist ties do not interfere with safe
operation of bicycle.
10
All manuals and user guides at all-guides.com
SPEEDOMETER INSTallaTION - SENSOR WIRINg
Computer
Sensor
OFF
Brake cable
Sensor wire
Magnet