Safety Instructions - HQ-Power VDLSTR Manual Del Usuario

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing HQPOWER! Please read the manual thoroughly before bringing this device into service. If the
device was damaged in transit, don't install or use it and contact your dealer.

2. Safety Instructions

CAUTION – Laser Radiation – Do Not Stare Into Beam – Class 3a Laser
Wavelength: 532nm – Max. Output Power: < 5mW – 21 CFR 1010.10
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
• For indoor use only. Keep this away from rain and moisture.
• Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
• Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if necessary.
• Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug only.
• Keep the device away from splashing and dripping liquids. Never put objects filled with liquid on top of the device.
• Clean the device using a soft and dry cloth. Do not touch the lenses with your fingertips, never submerge the
device in any liquid and never use abrasive detergents or cleaners.
• Note that damage caused by user modifications to the device is not covered by the warranty.
• Keep the device away from children and unauthorised users.
3. Description
1. PSU input jack
2. brightness control
3. on/off switch
4. star projector lens
5. cloud projector lens
6. pivot
7. PSU
4. Use
• Place your VDLSTR on a flat surface. Make sure the on/off switch is in the off position. Insert the power plug
of the PSU into the input jack (1). Connect the PSU to the mains.
• Point the projector towards the ceiling away from eyes.
• Darken the room and switch on your VDLSTR. Adjust the projected image using the brightness control. Turn it
completely to the right to add clouds to the sky. Turn it completely to the left to achieve a cloudless and starlit
sky.
• Switch off the projector after use. Never leave a switched-on projector unattended.
VDLSTR_v2
VDLSTR – LASER STAR EFFECT
3 HQPOWER