Safety And Operating Instructions - Etherma SOLAMAGIC S1 Instrucciones De Montaje Y De Uso

Safety and operating instructions

Please observe the following instructions:
• Carefully read through the instruction manual prior to installation and store the
manual safely.
• This heater is intended for outdoor installation, either attached to a building
wall or some other solid construction. It is not intended to be used indoors to
provide heating up to a pleasant temperature level.
• The heater must only be used by adults. Children must not play with the heater.
Children younger than 3 years old must be kept away from the heater unless
they are continuously monitored. Children younger than eight years old must
not switch the heater on and off, insert the plug in the socket, clean the heater
nor perform any maintenance work.
Caution - Some parts of this product can become very hot and cause burns.
Special care is required when children and vulnerable persons are present.
• Installation tasks must be properly carried out by a qualified person in ac-
cordance with VDE 0100 installation instructions (if applicable, also including
Parts 559 and 701).
• When carrying out any work, always switch the system to a zero-volt state
(disconnect mains plug; circuit-breaker off). Switch on the heater only after all
the cables have been completely connected.
• The heater must be connected to a switched domestic electrical supply protec-
ted by a fuse of rating at least 16A slow (type C16A).
• Do not install directly under sockets, junction boxes, switches or electrical
cabling.
• Electrical sockets may only be located in the positions specified in Appendix 2.
• Do not mount the radiant heater close to curtains or combustible materials in
accordance with VDE 0100, Part 559.
• The heater is as a minimum compliant to an IP24 degree of protection, provi-
ded all connectors (heater plug, plugs for expansion components) are plugged
in, and is approved for outdoor use.
• Never leave the heater unattended.
• Do not cover the heater when it is switched on or still hot; there is a risk of fire.
• To adjust the radiation direction, switch the heater off and allow to cool.
• Do not look directly at an operating IR halogen lamp for a long period and from
a short distance.
• IR halogen lamps are sensitive to direct skin contact (do not touch with bare
123