Settings; Warning Messages - VOSS.farming 41404 Instrucciones De Operación

7.4 SETTINGS

1.
To open the settings, press and hold the
a few seconds.
2.
Use the
ƒ If you have selected the letter "A", you can switch the alarm
sound of your remote control on or off.
ƒ Under the letter "U", select the interval for updating the data
of your energiser.
Info
»
»
ƒ You can also set a limit value for the fence. You select a value
and as soon as the fence falls below it, an alarm is triggered
on the remote control.

7.5 WARNING MESSAGES

The remote control shows you an error with a flashing warning sign
(an exclamation mark in the triangle). You will also hear a beep if
you have not muted it in the settings.
To switch off the warning tone, press the
switch off the sound completely in the settings. If you have corrected
an error, press the
No signal:
If the signal sign and the warning sign flash, the signal is weak.
Low fence voltage:
If the measuring unit flashes, the fence voltage is too low.
Energiser battery charge low:
If the symbols for the energiser battery and the alarm light flash,
the battery is empty.
18
INSTRUCTION MANUAL VOSS.FARMING REMOTE CONTROL
buttons to switch between the setting options.
An empty round arrow is an interval of 1 minute.
A round arrow with an "i" in the middle is a 1 hour
interval (this uses less energy and makes your
battery last longer). For a manual update, press
the button (12) on the remote control.
To reduce battery consumption, we recommend
setting the update interval to 1 hour.
button (11) and the error message is deleted.
button (14) for
button (11). You can also
41404 - 06.2022 - V1