Pairing Process - Hinkley 980014-R Instrucciones De Instalación

OPERATION
Your DC brushless motor is equipped with an automatically learned
type remote control. There is no frequency switches on the receiver or
transmitter. The fan can start to use once the pairing process is done.
Remove the panel from the transmitter and then install one 2032 battery
(included). You need to use a coin to open or close the battery cover. To
prevent damage to transmitter, remove the battery if not use for long
periods of time (Fig. 5)
WARNING: Chemical Burn Hazard. Keep batteries
away from children.
This product contains a lithium button/coin cell battery. If a new or used
lithium button/coin cell battery is swallowed or enters the body, it can
cause severe internal burns and can lead to death in as little as 2 hours.
Always completely secure the battery compartment. If the battery
compartment does not close securely, stop using the product, remove the
batteries, and keep it away from children. IF you think batteries might
have been swallowed or placed inside any part of the body, seek
immediate medical attention.
The batteries shall be disposed of properly, including keeping them
away from children; Even used cells may cause injury.
1. button:
Press this button and release instantly to turn on or off the light.
2. button:
Press this button to set fan wind direction up or down.
3. button:
Press and hold to dim or brighten lights to the desired level and
release.
4. button:
Press button for turn on and setting 1-6 fan speed.
5. button:
Press this button to turn the fan off.
6. Signal light (Fig. 6)

Pairing Process

With the fan's power off, restore power to the fan. Press and hold "
button for about 5 seconds and release. If optional light kit is installed,
the light kit will flash three times and the motor spin up for 10 seconds
on low speed. The fan has completed the pairing process with the wall
control and is ready for use.
NOTE: A single fan can be controlled with as many as 3 wall controls
in one room. Every control will need to repeat the pairing process based
on instructions above and all controls must be within 30 feet of the fan.
Fig. 5
Signal light
Fig. 6
"
ON
OFF