Permobil SpeedControl Instrucciones De Instalación página 3

PART TWO: Attach to the wheelchair.
The SpeedControl device is mounted on one side of the
wheelchair frame, in a location that ensures that you can operate
the dial without having to remove your hands from the handrims.
WARNING: Installing the SpeedControl dial too far from
the handrims may result in having to remove your hands from
the handrims during wheelchair operation, which could result
in losing control of the wheelchair.
If the wheelchair has screw-down seat upholstery, loosen the
screws and feed the clamp under the metal bar (then retighten
screws) to allow for the closer positioning of the SpeedControl to
the handrims.
Option A: Direct attachment
1. If using rubber insert #22, #25 or #28, place it onto the frame
tube. Otherwise, skip to 2.
2. Slide the square head bolt into the slot on the rear of the
housing.
3. Angle the clamp, as shown, and hook the top part of the
clamp onto the rear of the housing.
4. If using rubber insert #32, place into the clamp.
EN - SpeedControl Installation Instructions - 3
1
3
4
2