Permobil SpeedControl Instrucciones De Instalación página 6

7. Rotate the arm to a position that is comfortable. If
preferred, lock the arm into position by tightening the
outside screw, using the 5mm hex wrench.
8. Place the SpeedControl device in the arm "pocket".
Position the device so you can see the LED from a
seated position.
9. Secure the device to the arm with the M4 screw and
the provided 3mm hex wrench.
10. Route the cable through the slot on the arm.
11. Route the cable under the seat upholstery and out
the back of the wheelchair. Use the supplied hook
and loop fastener strips and zip ties to secure the
cable to the wheelchair frame and seat upholstery.
CAUTION: Check to make sure that the cable
doesn't protrude from the wheelchair, where it
could get caught and be damaged.
Note: Refer to the routing examples on the last page
of this manual.
EN - SpeedControl Installation Instructions
7
8
10
- 6
9