Permobil SpeedControl Instrucciones De Instalación página 8

Magnetic Holder for Cable Connector
When the cable connector is not connected to the
SmartDrive, it can be secured to the wheelchair with the
provided magnetic holder. This magnetic holder is attached
to the SmartDrive adaptive axle clamp.
WARNING: Installing the magnetic holder will affect
the installation of the SmartDrive adaptive axle clamp. The
attachment, position and orientation of the clamp is
critical to the correct function of the SmartDrive. When
performing the steps below, read and follow the "Axle
Clamp Mounting Instructions" to ensure the SmartDrive
functions safely and as intended.
To install the magnetic holder:
1. Position the magnetic holder (A) between the front and
back parts of the adaptive axle clamp (B).
2. Feed the top clamp screw (C) through the hole in the
holder, and securely tighten.
3. Tighten the bottom clamp screw.
Note: To prevent rattle, tighten the top clamp screw first, and
then tighten the bottom clamp screw.
EN - SpeedControl Installation Instructions - 8
C
A
B