Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Service
You acquired a modern product manufactured by FHF which was
subject to a strict quality assurance process. If you have any questions
concerning the phone, or in the event of a fault, even after the warranty
period, please contact FHF (see page 4). Please keep the type number
and item number at hand (you can find these code numbers on the
rating plate).
Care and Maintenance
The telephone is maintenance free. However, if the phone is used in
areas with heavy pollution with dust, grease, oil etc. it should be cleaned
regularly. Wipe the handset and the device with a damp cleaning cloth.
Attention! Never use sharp objects for cleaning.
Disposal
The device is disposed of as electronic waste.
Plastic, metal and electronic parts are to be disposed of separately upon
disassembly.
The requirements concerning disposal of the country of application are
to be observed.
Warnings and safety instructions
This is a weatherproof phone specifically developed for use in rough
industrial conditions. Please observe the following warnings and safety
instructions:
1. The phone is manufactured to comply with protection class II and
can only be connected and operated with the specified voltage.
Ensure correct connection of the device. The connecting wire shall
be routed not to cause a tripping hazard.
2. The phone may only be operated under the above-mentioned
environmental
environmental conditions, for example environmental temperature
too high or too low are not permitted because they can cause the
breakdown of electronic components.
3. Care must be taken to ensure that the phone and the connecting
wires etc. are not damaged. Do not use the phone if damaged.
4. The circuits of the telephone must not be earthed.
5. For the operation of the phone, legal and industrial requirements,
regulations
specifications must be observed.
6. Use
only
professionally. Other replacement parts can cause damage and it
will void the warranty.
7. Cut off the power supply before performing maintenance works or
replacement of the phone. If repair or maintenance work must be
24
conditions
for
the
prevention
original
parts
(see
Technical
of
accidents
for
repair,
which
data).
Adverse
and
electrical
were
replaced
Publicidad
Tabla de contenido
