HIKOKI RH 18DA Instrucciones De Manejo página 6

English
7. When working in elevated locations,
make sure there are no people or
fl ammable materials underneath.
Failure to observe this may result in
accidents.
8. Do not point the hot air directly at people
or animals. Do not look into the nozzle.
Do not use it as a hair dryer under any
circumstances.
Failure to observe this may result in
accidents or injury.
9. There are cases in which highly toxic
gas will be emitted if used on plastic,
lacquer or similar materials.
Always ensure that the work area is fully
ventilated, and wear a dust-protection
mask.
10. Apply heat gently while moving the Heat
Gun up, down, left and right.
Aiming it constantly at a single location
may result in the outbreak of smoke or
fi re.
11. Check the tool for damage, cracks or
malformation in the event of it being
accidently dropped or subject to impact.
Damage, cracks and malformation may
result in injury.
12. Cease operations immediately in the
event of the tool not operating properly
or if abnormal noises or vibrations
are noticed, and contact a HiKOKI
Authorized Service Center to request
inspections and repairs.
Continued use may result in injury.
13. Do not get away from the unit while it is
switched on. Always return the switch
to the OFF (○) position when you are
fi nished working. Failure to observe this
may result in accidents.
14. When removing the battery, please put
the switch in OFF (○) position.
CAUTION
1. Parts of the nozzle supplied are sharp,
so use gloves when removing them
from the case and when attaching or
detaching them.
2. The nozzle, the tip of the nozzle and the
material that was heated are extremely
hot during and immediately after using
the tool, so use gloves and avoid
touching them directly.
3. Do not use inside boxes, drawers or
other enclosed spaces.
Aiming it constantly at a single location
may result in the outbreak of smoke or
fi re.
4. Make sure the nozzle is at least 5 cm
away from the item being heated when
using the tool. Also, do not cover or
otherwise block the nozzle.
Failure to observe this may result in
the Heat Gun overheating, leading to
malfunctions.
5. Do not switch the tool on and off
repeatedly.
Failure to observe this may result in
malfunctions.
6. Do not point the nozzle downwards
immediately after use.
Failure to observe this may result
in the tool overheating, leading to
malfunctions.
7. Do not give a strong shock to the panel
or break it. It may lead to a trouble.
8. When storing, make sure the tool is
completely cooled. Failure to observe
this may cause burns or storage case
deformation.
6