H.Koenig bw1688 Manual De Instrucciones página 13

HOW TO CHANGE A KEG
When the beer in the keg runs out, before changing a new beer keg (Note: when changing keg,
make sure it is in the startup state, otherwise it cannot enter the initial state).
1. Open the top cover of the beer cooler.
2. Press down the quick connector assembly at the end of the beer pipe on the tap assembly, at
the same time turn the connector anticlockwise out of the engagement position of the wine
valve device, and then pull out the connector (as shown in figure 13).
3. Press and hold the white button of the air inlet quick socket (as shown in Figure 14), and pull
out the quick air inlet connector at the end of the beer pipe on the wine valve device from the
air inlet quick socket (as shown in Figure 15).
Figure 14
4. Take the empty beer keg with the beer valve out of the machine.
5. Press the left and right buttons on the beer valve device to pull the beer valve device out of
the empty beer barrel (as shown in Figure 16).
Figure 13
Figure 15
Figure 16