H.Koenig bw1688 Manual De Instrucciones página 16

Trouble
The tap does not
work/ can't pour
beer out
Too much bubble
pouring out
Beer flows out
too slowly
ENVIRONMENT
CAUTION:
Do not dispose of this product as it has with other household products.
There is a separation of this waste product into communities, you will
need to inform your local authorities about the places where you can
return this product. In fact, electrical and electronic products contain
hazardous substances that have harmful effects on the environment or human
health and should be recycled. The symbol here indicates that electrical and
electronic equipment should be chosen carefully, a wheeled waste container
is marked with a cross.
Adeva SAS / H.Koenig Europe - 8 rue Marc Seguin, 77290 Mitry-Mory, France
www.hkoenig.com - https://en.hkoenig.com - Tél: +33 1 64 67 00 05
Cause
1. The beer tube is in poor
connection
2. No keg or no beer in the
keg.
3. The quick air inlet
connection is not installed
properly.
1. Use a wrong way to pour
beer out
2. The beer temp is high
(better at 3-5℃)
3. The keg is shaken before
usage
4. Almost no beer in the keg
1. Foreign matter in pouring
tube.
2. The connection tube or
pouring tube has leakage.
Troubleshooting
1. Well connect the pouring
tube.
2. Change a new keg
3. Connect the quick air inlet
connector.
1. Turn the tap fully on
quickly. Check and find out
the correct distance
between the beer cup and
the tap when pouring beer.
The general height is from
3/4" to 1". The normal
bubble should be thick and
cream.
2. Cool the beer down to 3-
5℃.
3. Put the beer keg aside a
while till no bubble inside
4. Change a new keg.
1. Remove the beer pipe to
clean or replace the beer
pipe..
2. Check whether the tube
is leakage or not, if so
replace the tube.