H.Koenig bw1688 Manual De Instrucciones página 8

FIGURE 1
4. Check whether the infrared detection LED (As shown in Figure 3), on the left and right upper
part of the inner side of the device's refrigeration barrel, is dirty or damaged. If the beer keg is
not put into the refrigeration barrel or removed, the machine can not work normally, and the
display panel displays the "OP" code.
5. Remove the protective cover and beer tube of the beer keg.
6. Align the beer outlet valve device vertically with the connecting part of the beer keg in the
middle of the top surface of the beer keg, and immediately press it into the beer keg. When you
hear a click, it indicates that the wine outlet device has been correctly fixed on the beer keg (as
shown in Figure 5 below). After installing the valve device, put the beer keg into the refrigeration
barrel
FOR A 5L KEG: The connector that comes with your beer cooler can work with all Heineken (or
any pressurized) 5-liter kegs. However, you must use a flat head screwdriver to remove the
green base from the keg in order to install the new connector, provided with the beer cooler
(Figure 4).
FIGURE 2
Infrared detection LED lamp
FIGURE 3
of the machine.