STAMONY -VP-100 Manual De Instrucciones página 6

3.2. PREPARING FOR USE
ASSEMBLING THE DEVICE
3.2.1. OUTDOOR STATION INSTALLATION
1) Loosen the screws at the top and bottom of the
outdoor station using the wrench provided.
2) Separate the outdoor station from the installation
box.
1 2
3) Loosen the four screws on the back of the outdoor
station.
3
4) Connect the cable in accordance with the connection
diagram (section 3.2.3) and adjust the volume.
4
5) Remove the plate and write the name / apartment
number or other data on it.
5
1
2
EN
6) In the appropriate hole in the wall (110x158x57 mm,
1.4-1.7 m high) fix the installation box with screws.
6
7) Fasten the outdoor station to the installation box
and tighten the screws with the enclosed wrench.
7
3.2.2. INDOOR MONITOR INSTALLATION
Fasten the monitor holder to the wall with screws. Connect
the wiring according to the diagram (section 3.2.3)
After connecting the cables, place the monitor on the
holder, connect the power adapter, and then connect it to
the socket.
CAUTION: When choosing the mounting location for
internal monitors, refer to the guidelines in sections 2 and
3.4.
3.2.3. ELECTRIC SCHEMA
Outdoor station Monitor A Monitor B
10
Cables:
1. Audio
2. Grounding
3. Video
4. Power supply
8. Audio
Description
1. Ports 2,3,4 on the outdoor station should be
connected to terminals 012, 013, 014 on the indoor
monitor A and B.
2. Connection 1 on the outdoor station should connect
to connection 011 on indoor monitor A.
3. Connection 8 at the outdoor station should connect
to terminal 011 on indoor monitor B.
4. Connection + - on the internal monitor A and B
should connect to the charger.
5. Connections 5.6 at the outdoor station should be
connected to an electric lock.
Cable type: 4 connecting cables (4-wire RVV).
Maximum working distance: 50m.
3.3. DEVICE USE
3.3.1. RINGTONE SELECTION
1) To select a ringtone melody, press the icon shown in
the figure below.
2) Press again to change the melody. Then press „<" or
„>" to set the ringer volume.
3) To accept the changes, press „o".
1 2 3
4) To mute the monitor, press the icon shown in the
figure below. The LED indicating the mute mode
will light up on the top of the monitor. When the
connection is established, the monitor will not ring,
only the image will be visible.
4
3.3.2. CALLING
Press the first button on the outdoor station to connect
to monitor A. To connect to monitor B, press the second
button on the outdoor station. The monitor will then emit
sound in accordance with the settings and the screen will
show the image recorded by the camera of the outdoor
station.
EN
In order to start a conversation with a person outside, press
the icon shown in the figure. At the same time, the voice
connection indicator on the top of the monitor lights up.
To end the conversation, press the icon indicated in the
drawing again.
CAUTION: During the conversation it is possible to set the
volume, brightness and contrast of the screen.
3.3.3. OPENING THE DOOR
To open the door, press the icon shown in the figure.
3.3.4. CAMERA PREVIEW
To get a preview from camera 1 or 2, press the camera
preview icon with the appropriate number. The view time is
about 20 seconds, after which the screen turns blank.
While previewing the camera image, it is possible to unlock
the door, receive a voice call and set the contrast and
brightness of the screen.
CAUTION: The set includes one camera. To install a
second camera, connect it to monitor B in the „outdoor
2" connection.
11