Stanley FATMAX SFMCMWS251 Traducido De Las Instrucciones Originales página 16

ENGLISH
If the supply cord is damaged, it must
u
be replaced by the manufacturer or
an authorised STANLEY FATMAX
Service Centre in order to avoid a
hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/tool/battery must be
u
placed in a well ventilated area when
.
charging
The charger is intended for
indoor use only.
Read the instruction manual
before use.
#
Electrical safety
Your charger is double insulated;
therefore no earth wire is
required.
Always check that the mains voltage
corresponds to the voltage on the rating
plate.
Never attempt to replace the charger
unit with a regular mains plug.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or
an authorised STANLEY FATMAX
Service Centre in order to avoid a
hazard.
Features
This tool includes some or all of the following features.
1. On/Off switch box
2. On/Off button
3. Safety key
4. Handle
5. Bail handle
6. Handle locks
7. Handle brackets
16
(Original instructions)
8. Handle storage detent holes
9. Battery port cover
10. Cut height adjust lever
11. Rear door cover
12. Grass collection bag
13. Grass collection bag handle
14. Self drive bail handle
15. Self drive speed lever
Charging procedure
STANLEY FATMAX chargers are designed to charge
STANLEY FATMAX battery packs.
Plug the charger into an appropriate outlet before inserting
u
the battery pack.
Insert the battery pack into the charger.
u
The green LED will flash indicating that the
battery is being charged
The completion of charge is indicated by the
green LED remaining on continuously. The pack
is fully charged and may be used at this time or
left on the charger
Warning! Recharge discharged batteries as soon as possible
after use or battery life may be greatly diminished.
Charger diagnostics
This charger is designed to detect certain problems that can
arise with the battery packs or the power source.
Problems are indicated by one LED flashing in different
patterns.
Bad battery
The charger can detect a weak or damaged
battery.
The red LED flashes in the pattern indicated
on the label. If you see this bad battery blink pattern, do not
continue to charge the battery.
Return it to a service center or a collection site for recycling
Hot/cold pack delay
When the charger detects a battery that
is excessively hot or excessively cold, it
automatically starts a Hot/Cold Pack Delay, suspending
charging until the battery has normalized.
After this happens, the charger automatically switches to the
Pack Charging mode. This feature ensures maximum battery
life. The red LED flashes in the pattern indicated on the label
when the hot / cold pack delay is detected.