Tweco FUSION 250 Manual De Instrucciones página 17

6. Cut the copper strands to a length of ¾"
(19,05 mm) while leaving the wire leads
intact.
7. Thread the pressure nut onto the
replacement rear connector until it
bottoms out and then slide the sleeve
over the connector.
Note: Make sure the bevel is facing the
right direction.
8. Insert the replacement connector nipple
into the inner core tube of the Cablehoz.
It is recommended to use a small amount
of non-petroleum based lubricant* to help
the connector to slide into the tube. The
core tube should bottom out against the
shoulder, approximately 15/16" (23,8
mm) onto the connector.
*A small amount of white glue works well.
9. Push the copper strands underneath the sleeve. It is recommended that a 1/8" glass
filament tape be wrapped around the exposed copper to keep the copper strands together
when tightening the pressure nut.
10. Begin to turn the pressure nut counter-
clockwise which will force the copper
strands & sleeve against and then under
the machined taper on the connector.
Use Torque Wrench and wrench to
perform this task.
11. Torque the pressure nut to 250 inch
pounds, +/-50 inch pounds, (28,2 newton
meters, +/- 5,6 newton meters).
89200015
SAFETY AND OPERATING INSTRUCTIONS
All manuals and user guides at all-guides.com
15
Bevel