SYMBOLS
Warning
Read the manual
Do not dispose of batteries.
Return exhausted pack batteries
to your local collection or
recycling point
Contains Ni-Cd battery. Battery
must be recycled or disposed of
properly
1hour charging time
Do not expose to rain or water
Always charge the battery
between temperatures 32°F-
86°F(0°C-30°C).
Do not burn
Wear eye protection
Wear ear protection
18V Blower/Sweeper
All manuals and user guides at all-guides.com
ASSEMBLY
ASSEMBLING THE BLOWER TUBE
(Fig A.1 & Fig A.2)
Before assembling the BlowerTube, be sure the
on/off switch (2) is in ''O'' Off position.
Fit the BlowerTube to the motor housing as
shown in Fig A.1. Check the BlowerTube is
firmly secured.
WARNING! Do not attempt to operate or
disable the On/Off Switch by any means
other than the normal assembly or removal of
the tube.
NOTE: Before disassembling the Blower
Tube, be sure the on/off switch (2) is in ''O''
Off position. Press the Release Button , so that
you can separate the tube.(Fig A.2)Do not try to
separate the tubes by force or by using tools.
OPERATION
1. CHARGING YOUR BATTERY PACK
WARNING! The charger and battery
pack are specifically designed to work
together so do not attempt to use any other
devices. Never insert or allow metallic objects
into your charger or battery pack connections
because an electrical failure and hazard will
occur.
2. BEFORE USING YOUR
CORDLESS BLOWER
Your battery pack is UNCHARGED and you
must charge once before use.
When you charge the new battery or one which
has not been used for long periods of time, it
may not reach full charge until after you have
discharged it fully in use and recharge it several
times.
NOTE: If the tool will not be used for long
periods of time, charge the battery fully
before storage.
3. HOW TO CHARGE YOUR BATTERY PACK
(Fig B)
Connect the battery charger to the power supply
and the green light (8) will illuminate
fully insert the battery pack into the charger
to make the connections and the red light (9)
will illuminate to show charging has started
9
9
Then,
EN