Setup - Greenlee 2562 Manual De Instrucciones

Setup

Place the charger on a horizontal, hard surface.
• Keep the charger ventilation slots clear of any
obstructions. Do not place the charger on a soft
surface which could block the bottom ventilation
slots. The charger generates internal heat during
charging.
• Keep the charger away from any heat source.
Excessive internal heating can ruin the charger.
Failure to observe these warnings could cause the
generation of excessive heat or fire and result in
severe injury or death.
115 VAC / 230 VAC Charger
Plug the charger cord into a grounded wall receptacle.
Coil and wrap the unused power cord length with the
hook-and-loop tie strap.
12 VDC Charger
• Make sure the vehicle's electrical system is able
to supply the power required by the nameplate
rating. The vehicle's electrical system could be
overloaded, and the vehicle battery may run down
if not sized properly.
• In order for the charger's RECONDITIONING
cycle to work without interruption, the charger's
input power should not be turned off by the
vehicle's ignition switch. See the Operation and
Troubleshooting sections for details.
Greenlee Textron / Subsidiary of Textron Inc.
All manuals and user guides at all-guides.com
Battery Charger
Mounting Hole Locations
1. Locate hole positions from top left corner of charger.
2. Holes are designed for #8 pan head screw. Drill
either a through hole or a self-threading hole for the
#8 screw.
3. Install the screw through the battery pocket and
tighten.
4. Connect the red lead to the vehicle's "+" supply and
the black lead to the "–" supply. Note that the
charger will turn on when the second connection is
made.
1.5"
38.1 mm
3.02"
76.7 mm
50.8 mm
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070
7
– +
T S
2.0"