Worx WG151 Manual De Instrucciones página 43

gauge is recommended for an extension
cord of 25-ft, or less in length. Use
12-gauge for an extension cord of 50-ft.
Extension cords 100-ft. or longer are not
recommended.
8. INSPECt tool cords for damage. do
not operate battery charger with
a damaged cord or transformer/
plug, which could cause shorting
and electric shock. Have damaged
tool cords can be repaired at a qualified
Service Center.
9. do not operate battery charger if
it has received a sharp blow, been
dropped, or otherwise damaged
in any way. Take it to an authorized
serviceman for electrical check to
determine if the charger is in good
working order.
10. do not disassemble battery charger.
take it to authorized Parts and
repair Center when service or repair
is required. Incorrect reassembly may
result in a risk of electric shock or fire.
11. disconnect battery charger from
the power supply when not in use.
This will reduce the risk of electric shock
or damage if metal items should fall into
the opening in the charging stand. It also
will help prevent damage during a power
surge.
12. risk of electric shock. do not touch
un-insulated portion of output connector
or un-insulated battery terminal.
13. INdoor uSE – use in an indoor
location or where wet contact is not
likely to occur.
14. Save these instructions. Refer to
them frequently and use them to instruct
others who may use this tool. If you
loan someone this tool, loan them these
instructions also to prevent misuse of the
product and possible injury.
WArNINg: to prevent accidental
starting that could cause serious
personal injury, always remove the
battery pack from the tool when
assembling parts. use only the following
type and size battery(ies): WA3512,
WA3512.1.
Battery charger
SYMBOLS
Before charging, read the
instruction manual
Warning
Indoor use only
7 7
EN