Daily Maintenance; Storage Tips - Bionaire BU6000 Manual De Instrucciones

Before Cleaning, Please Note the
Following:
• DO NOT use soap, detergents, abrasives, gasoline,
glass or furniture polish, or boiling water to clean any
part of your Ultrasonic Humidifier. These will interfere
with the proper operation of your unit and may affect
its appearance.
• DO NOT use sharp or metal objects to clean mineral
deposits in the reservoir. Contact with sharp objects
can result in damage to the plastic.
• Mineral deposits should be soaked for up to 20 minutes
in plain vinegar and water to help with their removal.
• DO NOT clean any part of your humidifier in the
dishwasher.

Daily maintenance:

1. Before cleaning, turn the unit off and unplug the unit
from the electrical outlet.
2. Remove water tank from the base of the unit.
3. Drain and rinse the base and tank thoroughly to
remove any sediment or dirt. Wipe clean and dry
with a clean cloth or paper towel.
4. Fill the tank with water as per "Operating
Instructions" section of this manual.
5. If moisture forms on walls or windows in your home,
turn the humidifier off.
TROUBLESHOOTING
PROBLEM
There is not
enough mist
Mist has bad odour
Abnormal noise
All manuals and user guides at all-guides.com

STORAGE TIPS

If you do not plan to use the unit for an extended period
of time, it is important that you follow these instructions
to help prevent stagnation of water in the unit.
1. Turn the unit off and disconnect from the outlet.
2. Dry the unit thoroughly. DO NOT leave any water in
3. Pack the humidifier in its original carton and store in
SERVICE INSTRUCTIONS
1. DO NOT attempt to repair or adjust any electrical or
2. Should the unit stop working, first check the fuse
CAUSE
The Mist Control is on the
Lo Setting
Resonance from the surface
bearing the unit
Scale covers the transducer
The water is too dirty or the water
in the tanks has been kept there
too long, so it's not fresh
The machine is new or the water
is not clean
Resonance effect due to too little
water in the water tank
Resonance from the surface
bearing the unit
4
Remove the water tank, then empty the tank and the
base completely. Clean the humidifier as instructed
in the "Cleaning and Maintenance" instructions
section.
the unit when storing.
a cool, dry place.
mechanical functions on this unit. Doing so will void
the warranty. The insides of the unit contain no user
serviceable parts. Only qualified personnel should
perform all servicing.
in the plug (UK only) or fuse/circuit breaker at the
distribution board is operating, before contacting the
manufacturer or service agent.
SOLUTION
Change the Mist Control to Hi
Setting (see Mist Control
instructions)
Place the unit on a steady surface
or on the ground
Clean the transducer softly with
a damp cotton ball. Transducer
surface is delicate, avoid applying
excessive pressure.
Clean the water tank, change to
fresh, clean water
Open the water tank and place the
appliance in a cool area for 12 hours.
Wash the tank out or change thewater.
Refill water in the water tank
Place the unit on a steady surface
or on the ground