Jumper Settings - DFI Blood-Iron LanParty Bi 785G-M35 Guia Del Usuario

E
English
Chapter 2 - Hardware Installation

Jumper Settings

Clear CMOS Data
If you encounter the following,
a) CMOS data becomes corrupted.
b) You forgot the supervisor or user password.
c) The overclocked settings in the BIOS resulted to the system's instability or
caused system boot up problems.
you can reconfigure the system with the default values stored in the ROM BIOS.
To load the default values stored in the ROM BIOS, please follow the steps below.
1. Power-off the system then unplug the power cord.
2. Set JP10 pins 2 and 3 to On. Wait for a few seconds and set JP10 back to its
default setting, pins 1 and 2 On.
3. Now plug the power cord then power-on the system.
10
All manuals and user guides at all-guides.com
1 2 3
1-2 On: Normal
(default)
1 2 3
2-3 On:
JP10
Clear CMOS Data