Best D49M30SB Manual De Instrucciones página 7

INSTALL DUCTWORK
CAUTION: BEFORE CUTTING HOLE IN CABI-
!
NET FOR DUCTWORK, check for interference
with floor joists, wall studs, electrical wiring, or
plumbing.
1. Cut hole in cabinet as well as holes in wall or floor as neces-
sary.
2. Mount the roof or wall cap and work back towards the cabinet,
attaching all ductwork, elbows and transitions as previously
planned. Tape all ductwork connections to make them secure
and air tight.
3. Connect ductwork (and transition, if required) to downdraft.
If necessary, use (2) #8-18 x .375 phillips screws for transition.
INSTALL ELECTRICAL WIRING
Installations using FLEX BLOWER only:
CAUTION: All electrical wiring should be done
!
by a qualified person(s) in accordance with all
applicable codes and standards.
1. Mount a standard wiring box, with 3-pronged receptacle, within
reach of the downdraft's power cord.
2. Connect blower wires to wires in wiring box. Black to black,
white to white, blue to blue, orange to orange, gray to red, and
green to ground screw.
3. Replace wiring box cover.
4. Plug the downdraft's power cord into the outlet. Make sure that
the power cord is routed away from the heat generated by the
cooktop.
All manuals and user guides at all-guides.com
Models D49M30SB • D49M36SB • D49M48SB
Installations using REMOTE BLOWER only:
CAUTION: All electrical wiring should be done
!
by a qualified person(s) in accordance with all
applicable codes and standards.
1. Mount a standard wiring box, with 3-pronged receptacle, within
reach of the downdraft's power cord.
2. Run appropriate power cable into cabinet and connect it to
electrical box and receptacle.
3. These exterior or in-line blowers can be used:
Models EB6, EB9, EB12, or EB15 Exterior
Models ILB3, ILB6, ILB9 or ILB11 In-Line
120 VAC • 60 Hz • 6.0 A (max.)
WIRING BOX COVER
4. Run 2-wire plus ground power cable from the exterior or in-line
blower to wiring box on adaptor plate. Remove WIRING BOX
COVER.
5. Connect blower wires to power cable from exterior or in-line
blower. Black to black, white to white, and green to ground
screw.
6. Replace wiring box cover.
7. Plug the downdraft's power cord into outlet. Make sure that
the power cord is routed away from the heat generated by the
cooktop.
Page 7