Assembling The Appliance; Inserting The Batteries; Preparation - Beem Miracle Mop 10in1 Manual De Instrucciones

EN

Assembling the appliance

Attach the handle to the main body.
‹
Insert a fixing screw into the hole on
‹
both sides of the handle and screw in
with a suitable Phillips screwdriver (see
image A1).
Align the guide on the main body with
‹
the recess in the floor brush and push
the lower end of the main body into the
floor brush until it snaps in.
To remove the floor brush, press the
‹
release lever on the back of the floor
brush and pull the floor brush out of the
main body (see image B).
Using as a floor cleaner
Insert the hand-held steam cleaner into
‹
the main body.
Using as a hand-held steam cleaner
Take the hand-held steam cleaner out
‹
of the base appliance and mount the
desired nozzle as described in the
section Hand-held steam cleaner: at-
taching accessories (page 22).
BEEM - Elements of Lifestyle
All manuals and user guides at all-guides.com
To operate the UV lamp, you require 3 type
AA batteries (not supplied as standard).
‹
‹
‹
‹
‹
‹
‹
‹
Miracle Mop 10 in 1

Inserting the batteries

Press both locking latches together and
remove the cover (image A2).
Remove the batteries from the pack-
aging and put them into the battery
compartment (16). Pay attention to the
polarity indicated in the battery com-
partment (image A3).
Replace the cover and push it in until
the locking latches snap in.

Preparation

Filling the water tank
Press both tank release buttons (13)
und remove the water tank (see image
C1).
Turn the tank cover (6) 45° clockwise to
open it.
Fill with water to a maximum of 400 ml.
Close the water tank by turning the cap
45 clockwise (see image C2).
Push the water tank onto the appliance
until it audibly snaps in.
NOTE
► A metal ball is situated in the water
tank that is used as a weight for the
suction hose. Make sure that this
metal ball is always covered with wa-
ter so that steam can flow evenly (see
image C3).
21