Using The Remote Control; Maintenance; Cleaning The Pre-Fi Lter - atmosphere 10-1076 Manual Del Propietário

A
B
C
D
E
Fig. 16
Fig. 17
Fig. 18
Fig. 19
Filter Monitor Reset
Always be sure to reset the fi lter monitor after cleaning the pre-fi lter or replacing
either the Odor or HEPA fi lters. Press and hold the appropriate reset button
(located on the left side of the front display panel) with a pointed object for
about 3 seconds until the system beeps to confi rm reset. The monitor will begin
to blink when you press the button.

Using the Remote Control

The Remote Control has a lithium battery (type CR2032) already installed. To
use the Remote, simply point it toward the Air Purifi er and press the desired button
(A – Power, B – Auto, C – Turbo, D – Speed, E – Timer) (Fig 16).
NOTE: The buttons on the remote control have the same effect as those on the control panel.
For convenience the Remote Control can be stored in the slot on the back of
the Air Purifi er (Fig. 17).

Maintenance

Your ATMOSPHERE™ Air Purifi er should be cleaned and maintained regularly
for optimum performance.
As Needed
Wipe the housing exterior with a damp cloth and dry. If very dirty, use a mild de-
tergent, such as L.O.C.™ Multi-Purpose Cleaner. Do not use cleaners containing
ammonia, alcohol, or paint thinner. These cleaners will damage the surface.
Cleaning the Pre-fi lter and Particle Sensor Filter
1. Turn power off and unplug the Air Purifi er.
2. Remove the front cover from the Air Purifi er using the fi nger tabs located on
each side of the Air Purifi er – near the top (Fig. 18). Steady the Air Purifi er
by fi rst placing your thumbs on the outside edges of the control panel.
Remove the front cover by gently pulling on the tabs with your fi ngers. Then,
pull off the bottom of the cover.
3. Pull on the center tab to remove the Pre-fi lter from the HEPA fi lter (Fig. 19).
NOTE: Pull tab gently to minimize spread of accumulated dust.
12