Teka DSB Serie Manual De Instrucciones página 11

hood.
fitted at least 65cm above gas
or combination hobs. Observe the
minimum limits set by WORKTOP
MANUFACTURER'S
LIMITS. This distance may be
reduced if mentioned in the hood
installation instructions.
it. The grease accumulated in the filters may
drip or catch fire when the temperature is
increased.
filters are not fitted e.g. while they are being
cleaned in the dishwasher.
extra caution when cleaning the inside of the
hood.
and only for the extraction and purification
of gases from food preparation. Use for
other purposes is at your own risk and
may be dangerous. The manufacturer is not
responsible for damage caused by improper
use of the device.
nearest Technical Assistance Department
which will always use genuine parts. Repairs
or modifications by unauthorized personnel
may result in damage to equipment or
malfunction, endangering safety.
Directive 2002/96/EC on electrical and
electronic devices entitled "Electrical
and Electronic Equipment Waste ". The
directive provides the framework applicable
throughout the European Union for the return
and recycling of electrical and electronic
equipment waste [symbol] responsible for
his/her safety. Keep children away from the
device and never let them play with it
MINIMUM
1) Switch on the cooker hood and choose the
2) Push 'Timer'.
3) Select the required programming time
4) The display will alternately show the clock
Instructions for use
hood by operating the functions shown in
the diagram.
Switch on the extractor fan a few minutes
before you start to cook in order to ensure
that a steady air flow has been established
before fumes appear.
Allow the extractor fan to run for several
minutes after you have finished cooking in
order to expel all the grease from the outlet
duct. This prevents the return of grease,
smoke and smells.
Display
Timer
Decrease selected funtion
Increase selected funtion
Light
Program the working time
required aspiration speed.
from 1 to 99 minutes by using the buttons
'+' and '-'.
and the remaining programming time.
selected manually and will be changed
automatically to the second speed level
after approximately 10 minutes.
.