Symbol QRG SPT 1500 Manual De Instrucciones página 12

Troubleshooting
SPT 1500 terminal does not turn on:
• Adjust the contrast control.
• Make sure batteries are installed properly.
• Replace the batteries. If your SPT 1500 terminal still does not
operate, try a soft reset; see Resetting Your SPT 1500™.
Low battery warning after replacing the batteries:
• The battery warning message may appear immediately after
replacing the batteries. In addition, if you check the battery
gauge in the Applications Launcher immediately after replac-
ing the batteries, the gauge may start at "empty" and slowly
rise to "full." This is normal. It takes a few minutes for the
battery gauge to accurately show the condition of the batter-
ies.
No sound:
• Check the System Sound option in the General Preferences
screen. If the option is set to off, there will be no sound. See
the SPT 1500 Product Reference Guide for more information.
SPT 1500 terminal turns itself off:
• Your SPT 1500 terminal is designed to turn itself off after a
period of inactivity. This period can be set at one minute, two
minutes or three minutes. Check the "Auto-off after" setting
in the General Preferences screen, and change the setting if
you need a longer delay before the automatic shutoff feature
activates. See the SPT 1500 Product Reference Guide for
more information.
SPT 1500 terminal doesn't recognize my handwriting:
• For your SPT 1500 to recognize handwriting input with the
stylus, you need to use the Graffiti
SPT 1500 Product Reference Guide for information about
how to write Graffiti character strokes.
S P T 1 5 0 0
12
®
character strokes. See the