High Altitude Replacement Kit For Epaⅲ Engine - Raven GEN 4000 Manual Del Propietário

High Altitude Replacement Kit For EPAⅢ Engine
3000 ft. 6000 ft. or 6000 ft. 8000 ft. of elevation
At high altitude, the standard carburetor air-fuel mixture is too
concentrated and will cause performance to decrease and fuel
consumption to increase. An over concentrated mixture will also
foul the spark plug and cause difficulty when starting. Operation
at an altitude that differs from that at which this engine was
certified, for extended periods of time, may increase emissions.
The fuel system on this Engine or Equipment may be influenced by
operation at higher altitudes. Proper operation can be ensured by
installing an altitude kit when required. See the table below to
determine when an altitude kit is required. Operating this generator
without the proper altitude kit installed may increase the engine's
emissions and decrease fuel economy and performance. Kits may
be obtained from any Dealer, and should be installed by a qualified
technician.
Equiment model
Altitude Range*
Kit Part Number
* Elevation above sea level.
This high altitude kit is to be used at elevations above 3000 feet.
At elevations above 8000 feet, the engine may experience decreased
performance, even with the high altitude kit.
If a carburetor is replaced, the proper high altitude kit will need to be
installed into the replacement carburetor.
WARNING!
To prevent serious injury from fire: Follow the kit procedures in a well-
ventilated area away from ignition sources. If the engine is hot from use,
shut the engine off and wait for it to cool before proceeding.
NOTICE:
The warranty may be void if necessary adjustments are not made for
high altitude use.
GEN 4000 GEN 6500E
0-3000 ft
Not Required
18
3000-6000 ft
Altitude kit 1#
6000-8000 ft
Altitude kit 2#