START EXERCISING
With your desired profile downloaded onto the watch, you can start exercising and review exercise data records on the watch or uploading them to the application, which
can systematically manage and analyze your records.
IMPORTANT You need to pair sensor with the watch if necessary before starting exercising, such as paring a bike pod for cycling. If without pairing, the exercise profile
does not work to collect data.
CYCLING PROFILE
SETUP
Except wheel size setting, you could set up all for cycling profile following by the SETUP section in RUNNING PROFILE.
NOTE Make sure bike pod sensor is paired with the watch before cycling.
The setup mainly includes the following parts:
Lap
•
Interval
•
•
Rest
HR Zone
•
Wheel size
•
Wheel size setup
1. In CYCLING mode, press top (1) button to enter, and
the paired sensor icons display on the screen. Press
bottom (3) button to skip if the sensor is added.
2. Press middle (2) button to enter setup mode.
3. Toggle middle (2) button until adjust Wheel size displays.
4. Press top (1) button to enter.
5. Press top (1) button again to increase the value or press bottom (3) button to decrease the value.
6. Press middle (2) button to confirm selection.
USEFUL REFERENCE
About Bike Wheel Size
Match the ETRTO or wheel size diameter printed on the wheel with the wheel size setting at the right hand column of the table below. Input the relevant wheel size setting
number after bike pod is paired.
ETRTO
25-559
23-571
35-559
37-622
47-559
20-622
52-559
23-622
25-622
28-622
32-622
42-622
47-622
NOTE Wheel sizes on the above table are for reference only as wheel size depends on the wheel type and air pressure.
All manuals and user guides at all-guides.com
Wheel size diameter (inches)
26 x 1.0
650 x 23C
26 x 1.50
700 x 35C
26 x 1.95
700 x 20C
26 x 2.0
700 x 23C
700 x 25C
700 x 28
700 x 32C
700 x 40C
700 x 47C
2
Wheel size setting (mm)
1884
1909
1947
1958
2022
2051
2054
2070
2080
2101
2126
2189
2220