Team kalorik TKG CMM 1010 CW Manual De Instrucciones página 6

IMPORTANT INFORMATION
This appliance is not intended for long-lasting use. You should never exceed the maximum
operating time of 1 minute. Failure to follow this instruction carefully may result in damage
to the motor. Please make some operation breaks regularly. The breaks should last at least
3 minutes.
• Care is needed when handing cutting blade
• Remove the chopper blade before emptying the bowl.
• Never remove the cover over the chopper until the blade has completely stopped.
• Do not fill the beaker above 500g
BEFORE THE FIRST USE
• Wash the bowl, lid, chopper blade and axle unit in warm soapy water and dry
thoroughly.
• Wipe the motor unit and lid of the chopper with a damp cloth.
• Rinse the detachable metal leg under warm running water, wipe the blade with a
damp cloth and dry thoroughly.
• Remove the stainless steel whisk from the whisk body and wash in warm soapy water,
wipe the whisk body with a damp cloth and dry thoroughly.
SPEED SETTINGS
Depending on the accessory you are using, we recommend you to use the following
speed setting.
STICK ATTACHMENT:
WHISK:
CHOPPER:
USING THE STICK MIXER (motor unit and metal leg)
• Twist the stick blender onto the unit at anti-clockwise until it is locked. Then use gentle
hand pressure only to ensure that the shaft is fully tightened onto the motor unit.
• Put the ingredients into the bowl or a suitable container (such as a mixing bowl or pan).
Do not overfill to prevent splashing. The beaker must be not more than 2/3 full to
prevent over flowing.
• Do not use the stick blender to blend hard foods only, such hard foods only, such as
coffee bean, ice cubes, sugar, cereals, chocolate etc.
• Always use the stick blender to blend ingredients together with water or other liquid.
• Plug the unit into a suitable mains socket.
• Hold the unit securely and press the on/off button.
• When mixing liquids ensure the blade is fully immersed before switching on the
appliance to prevent splashing.
• Never remove the unit from the liquid until the blade has totally stopped spinning.
• When you take out the stick from the motor unit, make sure of it unplugged.
• Its blade is sharp; handle it with care to avoid any hurt of you.
TKG CMM 1010 CW
speed I or II
speed I
speed I or II
6