Maintenance And Care - smartmi P1 Manual De Usuario

Maintenance and Care

Power off purifier and disconnect it from the power supply before performing the following operations.
Cleaning the Filter Housing
1
Turn over the purifier and remove the
filter by rotating it counterclockwise.
2
Use a vacuum cleaner to remove dust
from the ventilation hole and cabin
walls, or wipe them using a soft cloth.
3
Re-install the filter after it has been
cleaned.
Note: Do not spray liquid onto the purifier's
casing, or wipe it using a wet cloth. This
could lead to drops of water leaking into the
base of the device.
Cleaning Laser Particulate
Matter Sensor
1
Turn over the purifier and remove the
filter by rotating it counterclockwise.
2
Use a screwdriver to loosen the
screws on the sensor cover.
Remove the cover and clean it with a
3
hair dryer or pneumatic air gun.
4
Once cleaning is finished, fix the cover
back onto the sensor and tighten the
screws.
Note: Do NOT clean with hot air.
13