Filter Cleaning - Haverland WaD-20 Manual De Instrucciones

3. Be sure to use a soft cloth, moistened with a mild
soap solution.
4. Do not use hard, abrasive or corrosive detergents or
solvants or any of the following as a cleaner: petrol,
thinners or benzene to clean the device.

FILTER CLEANING

1. Pull up the filtration mesh.
2. Clean filtration mesh with mild detergent and soft
brush.
Make sure filtration mesh is completely dry before
3.
installing.
WATER TANK CLEANING
1. Pull out the water tank.
2. Clean the water tank with a little mild detergent and
a towel and then rinse in water.
3. Put the water tank in place after cleaning.
AIR COOLER BODY CLEANING
1 . lt is advised to use a neutral detergent and a soft
cloth and to rub dry. Do not use solvants, acidic
detergents, petrol or alcohol etc. to clean the plastic
components, as these could be deformed or dama­
ged.
2. Clean with a damp cloth and allow to dry .
•
l
NOTE: If you do not use the product for a long period,
please empty the water tank.
STORAGE
Your air cooler can be stored assembled. lt is important
to keep it in a safe, dry location.
Problems Possible reasons
Air cooler is 1. The plug is not
not working. securely inserted
into the socket or
not well-connected.
2. The "ON/OFF"
button is not pres-
sed.
Air refreshing 1 . The mesh filter is
effect is not clogged with dust
right. and dirt, which af-
fects the unit's per-
formance.
2. The air vent is
obstructed.
COOL mode is 1. Lack of water in
not working. the water tank.
2. Damaged water
pump.
- 11 -
Solutions
1. lnsert the plug pin
into the wall socket
and make sure it is
connected well.
2. Press "ON/OFF"
button after plug-
ging.
1. Clean the mesh
filter.
2. Remove the fo-
reign abjects from
the air vent.
1. Turn off the
appliance and pour
water into the tank.
2. Contact your au-
thorized service.