•
Push the two hooks to put the filter back into the unit.
CLEANING MAINTENANCE
•
Before cleaning, be sure to disconnect the unit from any electric
supply outlet.
•
First clean the surface with a neutral detergent and wet cloth, and
then wipe it with a dry cloth.
•
Do not use gasoline or other chemicals to clean the unit.
STORAGE
•
Empty the water in the tank.
•
Roll up the power cord.
•
Clean the filter.
•
Store the unit in a cool and dry place.
TROUBLESHOOTING
Problem
Possible causes
The machine
doesn't work.
Dehumidificati
on function
cannot start.
The machine
makes noise.
E1 Code
Suggested solution
Instruction manual
Is the power line
Connect the plug into the
properly connected?
socket.
Full water indicator light
Drain the water in the tank
is on (water tank full or
and put it in place.
not in the right place).
The room temperature
The protection is started
is above 35 degrees or
and the machine will not
under 5 degrees.
work.
Is the lock on?
If the lock is on, please
unlock by press and hold
the lock button for 5
seconds.
Is the filter blocked?
Clean the filter (screen)
according to the cleaning
instructions.
Is the air inlet or outlet
Remove the obstruction
blocked?
from the air inlet or outlet.
Is the machine tilted?
Move the machine to a flat,
horizontal surface.
Is the filter blocked?
Clean the filter (screen)
according to the cleaning
instructions.
Coil sensor short circuit
Check if the line is loose or
or open circuit
replace the coil sensor.
EN
11