Lenco LBT-188 Manual Del Usuario página 11

3. Lift the anti-skating weight over the anti-skating weight wire support.
The anti-skating weight should now be dangling in free space to the left
of support.
Slip the loop of the anti-skating weight's thread over the 3nd groove of the
stub to set the correct anti-skating force for the factory-fitted cartridge. Feed
the thread through the loop of the wire support.
Anti-skating force adjustment
The anti-skating force must be adjusted corresponding to the down force as
follows:
Down force
5 - 10mN
10 - 15mN
15 – 20mN
20mN and bigger
Slip the loop of the anti-skating weight's thread over the 3rd groove of the
stub to set the correct anti-skating force for the factory-fitted cartridge. Feed
the thread through the loop of the wire support.
Groove in the stub
1 st from bearing rings
2 nd " " "
rd
3 " " "
4 th " " "
10