Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
01 – Basket
02 – Motor Housing
03 – Tank
04 – Resistance
05 – Oil Level
06 – Drainning Support
FEATURES
Maximum Load
Voltage
Power Rating
Height
Width
Depth
Net Weight
Gross Weight
Oil Capacity
3. INSTALLATION AND PRE-OPERATION
3.1 Placing
The Electric Fryer is to be installed onto a levelled, dry and
clean surface approximately 850mm high.
3.2 Electric Installation
This equipment was developed to work at 110 or 220 V.
Make sure that the unit voltage and the voltage in the power
source are the same.
The electrical feed cord has 3 round pins, one of them is the
ground wire. Its is mandatory that all 3 points are correctly
connected before the machine is turned on.
3.3 Terminal Equipotential
The figure indicates displayed beside the external connecting
terminal equipotential.
This should be used to ensure there is no potential difference
between different devices connected to the power grid,
reducing the maximum risk of electric shock.
The separate equipment must be connected to one another
by their respective equipotential connection terminals.
PICTURE 02
3.4 Security System
This machine is also equipped with a safety thermostat,
which has the function of disconnecting the electrical
resistance when the oil temperature reaches the maximum
allowable limit.
If during normal process of using the fryer, it off and not
07 – Control Panel
08 – ON/OFF Switch
09 – Thermostat Handle
10 – Pilot Lamp
11 – Thermostat Pilot Lamp
UNIT
FE-10-N
FE-10-N
kg
0,6
V
110
W
2000
mm
280
mm
300
mm
670
Kg
4
kg
5,2
L
5
return to restart, ie, the oil does not heat up again, turn off
the thermostat temperature, disconnect the machine from
the mains and wait for the complete cooling oil.
Then press the Reset button nº01 (Fig. 03) and note that the
button moves in, producing a sound and feeling a "plec". If
this occurs, it indicates that the safety thermostat has been
0,6
triggered, then do not use more equipment, taking it to a
220
Technical Assistance nearest Authorized.
2500
280
300
01
670
4
5,2
5
3.5 Pre-Operation
It is recommended to use the machine on a levelled, dry and
clean surface at all times, avoiding accidents.
Before turning on the machine, fill the Tank Nº03 (Pic.01)
with 5 liters of comestible oil, or until the level mark is
reached Nº05(Fig.01).
Please follow the illustrations below to correctly place the
hoop in the basket:
1) Fit the wire of the hoop wire in the lower housing of the
basket until the basket is well fit, as shown in pictures Nº04
and Nº05.
PICTURE 04
2) Press the upper portion of the hoop wire against the
upper housing of the basket until the basket is well fit, as
shown in pictures Nº06 and Nº07.
PICTURE 06
PICTURE 03
PICTURE 05
PICTURE 07
3
Publicidad
Tabla de contenido
