Technical Data; Protecting The Environment - Black and Decker REVJ12C Traducido De Las Instrucciones Originales

To minimise splintering, clamp a piece of scrap wood or
u
hardboard to both sides of the workpiece and saw through
this sandwich.
Sawing metal
Be aware that sawing metal takes much more time than
sawing wood.
Use a saw blade suitable for sawing metal. Use a finetooth
u
saw blade for ferrous metals and a coarser saw
blade for non-ferrous metals.
When cutting thin sheet metal, clamp a piece of scrap
u
wood to the back surface of the workpiece and cut through
this sandwich.
Spread a film of oil along the intended line of cut.
u
Accessories
The performance of your tool depends on the accessory used.
BLACK+DECKER accessories are engineered to high quality
standards and designed to enhance the performance of your
tool. By using these accessories you will get the very best
from your tool.
This tool is suitable both for U-shank and T-shank saw blades
Maintenance
Your BLACK+DECKER tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Your charger does not require any maintenance apart from
regular cleaning.
Warning! Before performing any maintenance on the tool,
remove the battery from the tool. Unplug the charger before
cleaning it.
Regularly clean the ventilation slots in your tool and
u
charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth. Do
u
not use any abrasive or solvent-based cleaner.
Regularly tap bit holder to remove any dust from the
u
interior.

Protecting the environment

Z
Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste..
Products and batteries contain materials that can be recov-
ered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
(Original instructions)

Technical data

Voltage
V
DC
No-load speed Min
Stroke Length mm
Max depth of cut:
Wood
mm
Steel mm
Aluminium
mm
Weight
kg
Level of sound pressure according to EN62841:
Power level, L 85,0 dB(A). Uncertainty, K
WA
Sound pressure L 74,0 dB(A) . Uncertainty, K
pA
Vibration total values (triaxial vector sum) determined according to
EN62841:
2
Cutting board (a ) 9,2 m/s , uncertainty (K) 1,5 m/s
h, B
Cutting sheet metal (a ) 12,5 m/s
h, M
Supply of Machinery (Safety)
Regulations 2008
REVJ12C Jigsaw
Black & Decker declares that these products described under
"technical data" are in compliance with:
The Supply of Machinery (Safety) Regulations, 2008, S.I.
2008/1597 (as amended),
EN62841-1:2015 , EN 62841-2-11:2016+A1:2020.
These products conform to the following UK Regulations:
Electromagnetic Compatibility Regulations, 2016,
S.I.2016/1091 (as amended).
The Restriction of the Use of Certain Hazardous Substances
in Electrical and Electronic Equipment Regulations 2012, S.I.
2012/3032 (as amended).
For more information, please contact Black & Decker at the
following address or refer to the back of the manual.
ENGLISH
REVJ12C
-1 0-2800/min
wood - 52mm
steel - 5mm
aluminium - 17mm
, 5 dB(A)
WA
,5 dB(A)
pA
2
2 2
, uncertainty (K) 1,5 m/s
12v
16mm
1.166
7