Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT! To ensure product Safety and
Reliability, repairs, maintenance and adjustment
(other than those listed in this manual) should be
performed by authorized service centers or other
qualified organizations, always using identical
replacement parts. Unit contains no user service able
parts inside.
CLEANING
WARNING! Blow dirt and dust from all ventilation
ducts with dry air, at least once a week. To reduce
the risk of injury, always use ansi z87.1 Approved eye
protection when performing this task.
WARNING! Never use solvents or other abrasive
chemicals to clean non-metallic parts of the tool. These
chemicals can weaken the plastic materials used in these
parts. Use a cloth dampened only with water and neutral
soap. Never allow liquid to penetrate inside the tool or
immerse any of the parts in a liquid.
ACCESSORIES
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center.
WARNING! The use of any accessory not recommended
for use with this tool could be hazardous.
PROTECTING THE ENVIRONMENT
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your BLACK+DECKER
product needs replacement, or if it is of no further
use to you, do not dispose of it with household waste.
Make this product available for separate collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the retailer
when you purchase a new product.
BATTERIES
BLACK+DECKER batteries can be recharged many
times. At the end of their useful life, discard
batteries with due care for our environment:
•
Run the battery down completely, then remove it from
the tool.
•
NiCd, NiMH and Li-Ion batteries are recyclable. Take
them to any authorized repair agent or a local recycling
station.
TECHNICAL DATA
Voltage
No-load speed
Stroke length
Max depth of cut:
Wood
Steel
Aluminium
Weight
CHARGER
Type
Input voltage
Frenquency
output voltage
Current
Charge time
BATTERY
Voltage
Capacity
Type
* Maximum initial battery pack voltage (Measured without a workload) is
20 volts. Measured under a workload, nominal voltage is 18 V.
BDCJS20
20 V
Max
Min
-1
0-2500
mm
19
mm
55
mm
8
mm
20
kg
1.85 (without battery pack)
AR B3 B2 BR
V
100 - 240
AC
Hz
50 / 60
V
8 - 20
DC
mA
400
Hours
3-4
LD120BAT
20 V
Max*
Ah
1.5
Lithium Ion
ENGLISH
33
Publicidad
Tabla de contenido
