Dust Extraction - Festool OF 2200 EB-F Instrucciones De Uso Original

English
9
9-6
9-1
9-2
9-3
9-4
9-5
8.7

Dust extraction

WARNING
Health hazard posed by dust
► Always work with an extractor.
► Only work with a fully functional chip
guard [10-2].
► Always wear a dust mask when performing
work that generates dust.
► Comply with national regulations.
A Festool dust extractor with an extractor hose
diameter of 1-7/16" (36 mm) or 1-1/16" (27 mm)
(1-7/16" (36 mm) recommended due to the re­
duced risk of clogging) can be connected to the
extractor connector [10-4].
Insert the extractor connector [10-4] as in im­
age [10]. The extractor connector can be turned
in the area of [10-3].
CAUTION! If an anti-static suction hose is not
used, static charge may occur. The user may
receive an electric shock and the electronics of
the power tool may be damaged.
Chip guard
The chip guard [10-2] can be engaged in an up­
per position, e.g. for cutter changes.
14
► Slide the chip guard upwards until it engag­
es or push the power tool downwards until
it reaches the limit stop.
To improve the efficiency of the dust extraction,
lower the chip guard while working.
► Press the lever [10-1] in the direction of the
handle.
10
10-1
Chip deflector KSF-OF
The chip deflector KSF-OF [11-1] (available as
an accessory depending on the model) can im­
prove the efficiency of the dust extraction sys­
tem when edge routing. The maximum cutter
diameter is 3" (78 mm).
The chip deflector is installed in the same way
as inserting the copying ring, see section 9.3.
A hacksaw can be used to cut along the
grooves [11-2] of the guard and therefore make
it smaller. The chip deflector can then be used
for inner radii down to a minimum radius of 2"
(52 mm).
10-4
10-3
10-2