Festool OF 2200 EB-F Instrucciones De Uso Original página 13

6
6-2 6-1 6-8
6-3
6-4
6-5
6-6
8.5 Rough/Precision routing
Fixed stop C has two stop planes with a height
difference of 1/16" (2 mm). This allows users to
route workpieces with a routing depth set using
stop C in two steps:
Rough routing
► Lower the power tool to stop plane [7-1].
Finishing routing
► Lower the power tool to stop plane [7-2].
Routing work can be performed as quickly
as with a large routing depth while still
producing a good surface quality. The final
routing depth is determined by the stop
plane setting [7-2].
6-7
7
B
7-1
8.6 Fine adjustment for edge trimming
The power tool has a special fine adjuster for
using cutters with a ball bearing guide. For ex­
ample, this makes it quick and easy to set a
precise transition when rounding edges without
a ridge, see figure [8].
8
Setting a precise routing depth
► First of all, roughly set the routing depth.
► Carry out a test rout.
► Open the clamping lever [9-2].
► Press the depth stop [9-3] against fixed
stop C [9-5].
► Clamp the depth stop to the turret stop us­
ing the eccentric [9-4] (turn clockwise).
► Close the clamping lever [9-2].
► Open the rotary knob [9-1].
► Precisely adjust the routing depth by turn­
ing the adjusting wheel [9-6].
It is possible to adjust the routing depth in
both directions thanks to the coupling be­
tween the depth stop and the turret stop.
► Close the rotary knob [9-1].
► Open the eccentric [9-4] (turn anticlock­
wise).
► If necessary, carry out additional test routs
and adjust the settings.
English
A
C
7-2
13