Installing The Loadbars - Gallagher G060 Instrucciones Para La Instalación

INSTALLING THE LOADBARS

Note: Do not use an arc welder on either the platform or the load bars. Use of an arc
welder may damage the load cells.
1. Position the load bars on the foundation to suit the platform or crate. The
load bars should be located as close as possible to the ends of the platform
or crate.
Important for Wireless loadbars:
For reliable communications the wireless module (orange box) end of the
loadbars, must be on the same side of the platform/ cattle handler that
faces the operator.
2. Ensure that the load bar feet sit flat on the board or concrete pad.
3. It is recommended that the load bars are secured to the foundation. To
secure the load bars, follow these steps.



Note:
Ensure that the load bar chassis does not twist or distort as the fasteners are
tightened. If the load bar feet do not sit flat on the foundation, grout or
pack the surface to suit.
Page 4
Mark the load bar feet holes on the foundation.
Drill and fit fasteners to suit the type of foundation. Dynabolts can be
used with concrete foundations; bolts, nuts and washers can be used
with board foundations.
Tighten the fasteners to secure the load bars to the foundation.
3E1045 Gallagher Loadbar User Manual