Basic Procedure - Kenwood KMM-BT332 Manual De Instrucciones

Installation/Connection
Part list for installation
(A) Faceplate (×1)
(C) Mounting sleeve (×1)
(E) Extraction key (×2)
* Supplied for /

Basic procedure

1 Remove the key from the ignition switch, then disconnect the
terminal of the car battery.
2 Connect the wires properly.
See "Wiring connection" on page 30.
3
Install the unit to your car.
See the following "Installing the unit (in-dash mounting)".
4
Connect the terminal of the car battery.
5 Press B SRC to turn on the power.
6
Detach the faceplate and reset the unit within 5 seconds. (Page 4)
28
ENGLISH
(B) Trim plate (×1)
(D) Wiring harness (×1)
(F) Screws*
M5 × 7 mm (×4)
M5 × 6 mm (×4)
M4 × 8 mm (×1)
.
Installing the unit (in-dash mounting)
1
2
Hook on the top side
Orientate the trim
plate as illustrated
before fitting.
Do the required wiring.
(Page 30)
Dashboard of your car
Bend the appropriate tabs to hold the sleeve
firmly in place.